Tapered Fairing Mount Mirrors
J062142016-05-16
GENERAL
Kit Number
56000098A, 56000099A
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
This instruction sheet references service manual information. A service manual for this year/model motorcycle is required for this installation. One is available from a Harley-Davidson dealer.
Kit Contents
See Figure 2 and Table 1.
INSTALLATION
Installing Mirrors
WARNING
To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)
1.
See the service manual. Remove main fuse.
NOTE
Do not leave windshield in place with outer fairing removed. Windshield could fall and be damaged.
2.
See the service manual. Remove windshield. Remove outer fairing.
3.
Drill mirror mounting holes.
a.
See Figure 1. Locate drill points (1 and 2).
b.
Cover the finished surface opposite of the drill points with masking tape to prevent damage to painted surfaces.
c.
Drill a 1/8 in. pilot hole in the center of each drill point (1 and 2).
d.
Drill a 29/64 in. hole at drill point (1) with a twist drill bit.
e.
Drill a 9/32 in. hole at drill point (2) with a twist drill bit.
f.
Remove tape.
g.
Repeat previous step on opposite side.
NOTE
Mirror assemblies and backplates are marked with an R or L to indicate the left and right side assemblies.
4.
See Figure 2. Install mirror assembly (1).
a.
With the locating pin (A) of the mirror assembly (1) inserting into the lower hole, install the mirror assembly.
b.
Install mirror base (2) and gasket (5).
c.
Install backplate (3) over mirror assembly, so that the locating pin is secured in the small hole of the backplate.
d.
Install flange nut (4). Tighten to 2.3–3.4 N·m (20–30 in-lbs).
e.
Repeat previous step on opposite side.
5.
See the service manual. Install the outer fairing and windshield.
6.
See the service manual. Install main fuse.
1Upper drill point
2Lower drill point
Figure 1. Drill Points (Left Side Shown)
SERVICE PARTS
Figure 2. Service Parts: Fairing Mount Mirrors
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Mirror assembly, left, black
Not Sold Separately
Mirror assembly, left, chrome
Not Sold Separately
Mirror assembly, right, black (not shown)
Not Sold Separately
Mirror assembly, left, chrome (not shown)
Not Sold Separately
2
Mirror base mount, left, black
56000113A
Mirror base mount, left, chrome
56000112A
Mirror base mount, right, black (not shown)
56000105A
Mirror base mount, right, chrome (not shown)
56000103A
3
Backing plate, left
56000015
Backing plate, right (not shown)
56000016
4
Flange nut (2)
7687
5
Gasket (2)
56000122
Items mentioned in text.
A
Locating pin
B
Small hole