Fuel Tank Trim
Kit Number
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
See Figure 1 and Table 1.
  1. Remove seat. See the owners manual.
  • Ambient temperature should be between 21 °C (70 °F) and 38 °C (100 °F) for proper adhesion. Do not apply below 10 °C (50 °F).
  • Parts cannot be repositioned after initial adhesive installation.
  • Allow AT LEAST 24 hours after application before exposing the area to vigorous washing, strong water spray or extreme weather.
  • The adhesive bond will increase to maximum strength after about 72 hours at normal room temperature.
  • Do not clean with denatured alcohol, mineral spirits or other solvents. Damage to components may occur.
  1. Using a 50:50 isopropyl alcohol/water solution, thoroughly clean trim mounting surfaces. Allow to dry completely.
  2. Place rubber gasket on fuel tank.
    1. See Figure 1. Use notches in gasket to align to the tank mounting bolt center and the steer head bolt center.
  3. Install fuel tank trim.
    1. With the adhesive backing still in place, test fit the fuel tank trim to mounting location.
    2. NOTE
      See Figure 2. If other adhesive pads are present other than the 3 shown, remove additional pads.
    3. Remove the adhesive backing.
    4. Install the fuel tank trim to the tank.
    5. Press surface of trim firmly to make sure that there is good adhesion.
3Upper notch
4Lower notch
Figure 1. Fuel Tank Trim Kit
Table 1. Fuel Tank Trim Kit
Part Number
Not Sold Separately
Not Sold Separately
Figure 2. Adhesive Strip Areas