WINDSHIELD KIT
J060112015-04-20
GENERAL
Kit Numbers
57400270, 57400271, 57400279, 57400280, 57400281, 57400310
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
This kit contains one windshield.
REMOVAL
  1. See Figure 1.Remove the two inner screws (3) and nylon washers (4). Loosen outer screws (3).
  2. Remove windshield. Leave the rubber trim strip (2) in place.
1Windshield
2Rubber trim strip
3Screw (4)
4Nylon flat washer (4)
Figure 1. Windshield Installation
INSTALLATION
1.
Put the windshield into position. Install the mounting screws (3), with the nylon washers (4). Make sure that the nylon washers are outside of the windshield.
2.
Tighten mounting screws from the center to the outside edge on both sides. Tighten screws to 0.9–1.3 N·m (8–12 in-lbs).
CARE AND CLEANING
NOTICE
Polycarbonate windscreens/windshields require proper attention and care to maintain. Failure to maintain polycarbonate properly can result in damage to the windscreen/windshield. (00483d)
  • Do not use benzene, paint thinner, gasoline or any other type of harsh cleaner on the windscreen/windshield. Doing so damages the surface.
  • Do not clean in hot sun or high temperature.
  • Powdered, abrasive or alkaline cleanser damages the windscreen/windshield.
  • Sunlight reflections off the inside curvature of a windscreen/windshield can, at certain times of the day, cause extreme heat build-up on motorcycle instruments. Exercise care in parking. Park facing the sun, place an opaque object over the instruments, or adjust the windscreen/windshield to avoid reflections.
NOTE
Harley-Davidson Windshield Water Repellent Treatment (Part No. 99841-01) is approved for use on Harley-Davidson polycarbonate windshields.