FINNED SPARK PLUG TRIM
J062952017-01-16
GENERAL
Kit Number
25800061, 25800062
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
See Figure 2 and Table 1.
INSTALLATION
Figure 1. Trim Installed
1.
See Figure 1. Center finned trim in the spark plug opening and press into place.
2.
Tap lightly with a plastic or rubber mallet to verify it is secure.
3.
Repeat steps with remaining left spark plug.
REMOVAL
1.
NOTE
Spark plug access does not require removal of finned trim.
See Figure 2. Locate spring clip (2) on the underside of finned trim (one on each side of trim).
2.
Using small screwdriver or pick, gently press down on spring and rotate that side outward.
3.
Repeat on opposite side of trim until spring is disengaged.
4.
Repeat for remaining cylinder head if needed.
SERVICE PARTS
Figure 2. Service Parts: Spark Plug Trim Kit
Table 1. Service Parts: Black
Item
Description (Quantity)
Part Number
1
Spark plug trim (2)
Not Sold Separately
2
Spring clip (2)
12200141
3
Screw (4) (not shown)
10200246