CYLINDER BASE COVER KIT
J063092016-08-16
GENERAL
Kit Number
25700632
Models
For the most up-to-date model fitment information see the product label or www.harley-davidson.com.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for installation. One is available from a Harley-Davidson Dealer.
Kit Contents
See Figure 2 and Table 1.
There are no Service Parts available with this kit.
INSTALLATION
1.
See Figure 1. See the service manual. Disassemble shifter linkage assembly (1).
2.
Remove the crankcase screw (2) centered between the cylinders as shown. Discard screw.
3.
See Figure 2. Install rubber caps (3) over remaining engine case hex flange screws. These screws are covered by the installed cylinder base cover.
4.
Install the cylinder base cover using button head cap screw (4). Tighten screw to 20–26 N·m (15–19 ft-lbs).
5.
See Figure 1. See the service manual. Reassemble the shifter linkage assembly (1).
1Shifter linkage assembly
2Crankcase screw
Figure 1. Disassemble shifter linkage. Remove crankcase screw
SERVICE PARTS
Figure 2. Service Parts: Cylinder Base Cover Kit
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Cylinder base cover
Not Sold Separately
2
Spacer, cylinder base cover
Not Sold Separately
3
Cap, rubber (2)
Not Sold Separately
4
Screw, button head Torx, 5/16-18 x 3-1/2 in
Not Sold Separately