FLRT UPRIGHT & DOCKING KIT
J057602016-03-04
GENERAL
Kit Number
52300324A, 52300415
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Electrical Contact Lube (H-D Part No. 11300004) or equivalent is required for the proper installation of this kit. This item is available from a Harley-Davidson dealer.
Kit Contents
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
INSTALLATION
1. See Figure 1. Using a plastic screwdriver, or your finger nail, remove trim covers (2) from the body (1).
1Body
2Cover
3Backrest dock
4Screw
Figure 1. Trim Cover
2. Install the backrest docks (3) using the two screws (4) for each dock. Tighten to 13.56 N·m (120 in-lbs).
3. See Figure 2. Press release button (1) on backrest dock while inserting one leg of the upright. Press release button on other backrest dock while inserting the opposite leg of the upright.
4. While holding both legs of the upright, firmly press the upright further into the backrest docks. The release buttons pop out to the original position.
NOTE
The release buttons must return to the original, extended position to complete the installation.
5. See Figure 3. If the fit of the upright in the docks is not snug, remove the installed O-rings and replace with the larger diameter O-rings. Repeat steps 3 and 4.
NOTE
A small amount of electrical contact lube (H-D Part No. 11300004) can be applied to the surface of each O-ring to aid in installation.
1Release button
2Backrest dock
Figure 2. Release Button Locked Position
When upright is removed plugs (5) can be installed. See Figure 2. Follow steps 3-5 for installing or removing plugs.
NOTE
Plugs do not require or use O-rings.
SERVICE PARTS
Figure 3. Service Parts: FLRT Upright & Docking Kit
Table 1. Service Parts: FLRT Upright & Docking Kit
Item
Description (Quantity)
Part Number
1
Upright, backrest, chrome
Not sold separately
Upright, backrest, black
Not sold separately
2
Backrest dock assembly, chrome (2)
52300326A
Backrest dock assembly, black (2)
52300419
3
Screw (4)
94595-98
4
O-ring service kit
91700038
  • O-ring, smaller diameter (2)
Not sold separately
  • O-ring, larger diameter (2)
Not sold separately
5
Plug, chrome
12100080
Plug, black
12100098