SOLO TOURING SEAT
J063862017-10-16
GENERAL
Kit Number
52000253
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
This kit contains one solo seat.
INSTALLATION
1.
See the owner's manual. Remove seat.
2.
Remove grab strap and nuts. Retain the nuts.
3.
See Figure 1. Remove two nuts (1). Leave the plastic stud plate retaining washers (2) in place.
4.
If installing seat with a passenger pillion, refer to pillion instruction sheet to install pillion and grab strap. Additional hardware may be required to mount a pillion.
WARNING
After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury. (00070b)
5.
Slide the new solo seat into position until front tab engages frame and rear of seat locates over mounting studs. Install seat mounting nuts onto the studs.
1Nut (2)
2Stud plate retaining washer (2)
Figure 1. Remove Nuts