FOLDING HEEL SHIFTER KIT
J043042017-10-30
GENERAL
Kit Number
33876-07
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Loctite® 243 (Blue) Threadlocker and Sealant (H-D Part Number 99642-97) is required for the proper installation of this kit.
Proper installation of this kit also requires the re-attachment of the shifter peg. If replacement of the original equipment (O.E.) shifter peg is needed, refer to the Parts Catalog for your year and model vehicle.
See the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only) for a selection of Genuine Motor Accessory shifter pegs that are available. These can be easily installed at the same time as this kit.
Kit Contents
See Figure 1 and Table 1.
REMOVAL
NOTE
Before removing the original heel shift lever, note the orientation. You may want to replace the lever at the same angle.
1.
Remove shifter peg from original heel shift lever if reusing.
2.
Remove original heel shift lever or shifter shaft cover. Retain socket head screw.
INSTALLATION
1.
See Figure 1. Position new heel shift lever so screw hole counterbore is facing down and at desired angle.
NOTE
Original equipment heel shift lever may have socket head screw installed from the top or bottom depending on the model motorcycle. Install new heel shift lever so mounting screw installs from the bottom.
2.
Slide lever onto splined shifter shaft, aligning screw hole with notch on shaft.
3.
Apply Loctite 243 (blue) to socket head screw removed earlier.
LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
4.
Insert screw into counterbored hole. Tighten.
Torque: 32–35 N·m (24–26 ft-lbs) socket head screw
NOTE
For proper installation, ensure that the heel shifter is completely installed on shifter shaft and applied torque meets but does not exceed given range.
5.
If using original shifter peg, apply Loctite 243 (blue) onto screw threads.
LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
6.
Install shifter peg onto new shift lever. Tighten.
Torque: 11–16.4 N·m (97–145 in-lbs) Shifter peg screw
7.
Check for proper operation and clearance.
SERVICE PARTS
Figure 1. Service Parts, Folding Heel Shifter Kit
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Lever, heel shifter
Not sold separately
2
Pivot, heel shifter lever
33897-07
3
Spring
33085-74
4
Ball
8861
5
Clevis pin
33806-08
6
Retaining ring
11665