EXTENDED HEEL/TOE SHIFT LEVER KIT
J054342017-10-30
GENERAL
Kit Number
33600001
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Loctite® 243 (Blue) Threadlocker and Sealant (Part Number 99642-97) is required for the proper installation of this kit.
Kit Contents
See Figure 1 and Table 1.
REMOVAL
NOTE
  • The original equipment shift levers have the socket head screws that secure the shift levers to the splined shifter shaft installed from the top or bottom, depending on your model motorcycle.
  • When toe and heel levers are positioned correctly, the socket head cap screws will be installed from the top of the levers.
1.
Remove original shifter pegs and retain for installation to new levers if desired.
2.
Remove socket head screws that clamp the shift levers onto the splined shifter shaft.
3.
Remove original equipment shift levers. Discard screws.
INSTALLATION
1.
Position toe shifter lever (1) at the desired angle and so the counterbored screw hole is facing up.
NOTE
The extended shift levers from this kit have the socket head screws installed from the top for both shift levers.
2.
Slide toe shifter lever onto splined shifter shaft.
3.
Align screw hole with notch on shaft.
4.
Position heel shifter lever (2) at the desired angle and so the counterbored screw hole is facing up.
5.
Slide heel shifter lever onto splined shifter shaft, Aligning screw hole with notch on shaft.
6.
Apply Loctite 243 (blue) to socket head screws (3).
LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
7.
Insert screws into counterbored holes. Tighten.
Torque: 32–35 N·m (24–26 ft-lbs) socket head screw
NOTE
For proper installation, ensure that the toe and heel shifter are completely installed on shifter shaft and applied torque meets but does not exceed given range.
8.
Apply Loctite 243 (blue) onto shifter peg screw threads if using original pegs.
LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
9.
Install shifter pegs onto new shift levers. Tighten.
Torque: 11–16.4 N·m (97–145 in-lbs) Shifter peg screw
10.
Check to make sure the extended levers have enough clearance for proper operation.
SERVICE PARTS
Figure 1. Service Parts: Extended Reach Shift Lever - Heel and Toe
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Toe shifter, chrome
Not Sold Separately
2
Heel shifter, chrome
Not Sold Separately
3
Hex socket head cap screw (2)
3275