SOFTAIL PASSENGER FOOTPEG MOUNTING KIT
J064022016-11-29
GENERAL
Kit Number
50500769 (black), 50500771 (chrome)
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for this year/model motorcycle is required for this installation. One is available from a Harley-Davidson dealer.
Kit Contents
REMOVAL OF STOCK SUPPORTS (IF EQUIPPED)
1.
See Figure 1 Remove e-clip (8) and clevis pin (3) from footpeg support (1). Remove footpeg (5), and retain for later use.
2.
Remove detent plate (4), detent spring (6), and detent ball (7) from footpeg support.
3.
Remove socket head cap screw (2) and footpeg support (1) from vehicle.
1Footpeg support
2Socket head cap screw
3Clevis pin
4Detent plate
5Footpeg
6Detent spring
7Detent ball
8E-clip
Figure 1. Softail Passenger Footpeg
INSTALLATION
Reference Figure 1 for installing new footpeg parts on vehicle.
1.
Remove plastic plug in frame, if equipped.
2.
NOTE
Ensure clocking bump on frame matches up with divot on footpeg support.
See Figure 2. Position footpeg support (6) on vehicle. Install socket head cap screw (4) through footpeg support and into threaded hole of frame. Tighten to:
Torque: 50–70 N·m (38–48 ft-lbs)
3.
NOTE
Footpeg was previously removed from vehicle or purchased separately.
Install detent spring (2) and detent ball (1) into end of footpeg.
4.
NOTE
For proper footpeg operation, the two small holes of detent plate must be on the bottom.
Install detent plate (3) into end of footpeg support (6).
5.
Align footpeg with footpeg support and install clevis pin (7) and e-clip (5).
SERVICE PARTS
Figure 2. Service Parts, Passenger Footpeg Mounting Kit
Table 1.
Kit
Item
Description (Quantity)
Part Number
50500769
1
Detent Ball (2)
Not Sold Separately
2
Detent Spring (2)
Not Sold Separately
3
Detent Plate (2)
Not Sold Separately
4
Socket Head Cap Screw (2)
4339A
5
E-Clip (2)
50500701
6
Passenger Footpeg Support, Black (2)
Not Sold Separately
7
Clevis Pin (2)
50500702
50500771
1
Detent Ball (2)
Not Sold Separately
2
Detent Spring (2)
Not Sold Separately
3
Detent Plate (2)
Not Sold Separately
4
Socket Head Cap Screw (2)
4339A
5
E-Clip (2)
50500701
6
Passenger Footpeg Support, Chrome (2)
Not Sold Separately
7
Clevis Pin (2)
50500702