INNER FAIRING GAUGE TRIM KIT
J060272017-08-23
GENERAL
Kit Numbers
61400260, 61400317, 61400399, 61400359, 61400360, 61400361
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
There are no service parts available for this kit.
PREPARATION
Preparation for All Trim Pieces
NOTICE
Do not clean with denatured alcohol, mineral spirits, or other solvent products, or component damage may occur. (00411c)
1.
NOTE
Mounting surfaces must be above 16 °C (60 °F) for the trim piece to adhere.
Use a 50:50 isopropyl alcohol/water solution to clean the mounting surface for each component.
2.
Allow the surface to dry completely before continuing to install kit.
3.
NOTE
Trim rings cannot be repositioned after initial installation. Verify that they are properly aligned before pressing into place.
Test the fit of the trim piece before removing adhesive backing of the double-sided tape or the trim piece.
INSTALLATION
Install Small Instrument Bezel Covers
  1. See Figure 1. Take a 76 mm (3 in) long piece of tape (1) from the kit. Cut tape into four equal pieces.
  2. Remove the liner from one side of the tape and apply the tape (spaced equally) to the instrument bezel (2). Press firmly.
  3. Remove the remaining liner from the tape.
  4. Position instrument bezel cover (3) over gauge. Press firmly into place.
NOTE
Let the adhesive cure for at least 24 hours at no less than 16 °C (60 °F).
  1. Repeat for remaining gauges.
Install Large Instrument Bezel Covers
  1. See Figure 1. Take a 152 mm (6 in) long piece of tape (4) from the kit. Cut tape into eight equal pieces.
  2. Repeat steps 2 - 5 under "Install Small Instrument Bezel Covers".
1Adhesive tape, double side-sided 3 in length (2) (cut into four pieces)
2Instrument bezel, small
3Bezel cover, small (2)
4Adhesive tape, double side-sided 6 in length (2) (cut into eight pieces)
5Instrument bezel, large
6Bezel cover, large (2)
Figure 1. Trim Rings and Adhesive Tape