Chrome Forward Control Bracket Kit
J064402017-08-22
GENERAL
Kit Number
50500695, 50500696
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
KIT CONTENTS
See Figure 3 and Table 1.
REMOVAL
Remove right side forward control bracket and left side forward control bracket. See service manual.
INSTALLATION
RIGHT SIDE
1.
See Figure 1. Position right side forward control bracket (3).
1Footboard assembly
2Clevis pin
3Right side forward control bracket
4Torx head button screws
5Torsion spring
6Retaining clip
Figure 1. Right Side Forward Control
2.
Install two 3/8-16 x 1.625 torx head button screws (4). Tighten.
Torque: 54.2–61 N·m (40–45 ft-lbs)
3.
Insert short leg of torsion spring (5) into hole in footboard (1). Align long leg of torsion spring (5) to hole in footboard mount and insert. Rotate footboard (1) into position in clevis and insert clevis pin (2) through clevis, footboard (1) and spring (5). Install retaining clip (6).
LEFT SIDE
1.
See Figure 2. Position left side forward control bracket (3).
1Footboard assembly
2Shifter lever
3Left side forward control bracket
4Retaining clip
5Torsion spring
6Torx head button screws
7Clevis pin
8O-rings
9Spacer
10Shift lever assembly
11Pinch bolt
12Bearings (part of left side forward control bracket)
13Shift lever shaft
Figure 2. LEFT SIDE FORWARD CONTROL
2.
Install two 3/8-16 x 1.625 torx head button screws (6). Tighten.
Torque: 54.2–61 N·m (40–45 ft-lbs)
3.
Verify inner O-ring (8) is in place on shift lever shaft (13) and position shifter lever in left side forward control bracket (3).
4.
Install outer O-ring (8) and spacer (9) on shift lever shaft (13).
5.
Install shifter assembly (10) and install pinch bolt (11). Tighten.
Torque: 12.2–16.2 N·m (9–12 ft-lbs)
6.
Insert short leg of torsion spring (5) into hole in footboard (1). Align long leg of torsion spring (5) to hole in footboard mount and insert. Rotate footboard (1) into position in clevis and insert clevis pin (7) through clevis, footboard (1) and spring (5). Install retaining clip (4).
SERVICE PARTS
Figure 3. Service Parts: Chrome Forward Control Bracket Kit
Table 1. Service Parts: Chrome Forward Control Bracket Kit
Item
Description (Quantity)
Part Number
1
3/8-16 x 1.625 Chrome torx head button screws (4)
10200536
2
Chrome right side forward control bracket
50500915, 50500918
3
Chrome left side forward control bracket
50500919, 50500920