Kit Number
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of (English only).
Do not use windshield bags with flamed windshields. Damage to graphics will occur. (00393f)
Weight Restriction
Please refer to the weight limit label found inside the right-side pouch.
Kit Contents
See Figure 3 and Table 1.
1. See Figure 1. Remove the center, inner left and inner right acorn nuts (7) from the horizontal windshield bracket (5). The two outermost acorn nuts can remain in place.
2. Peel the liner from the adhesive backing of a rubber bumper (1) from the kit. Carefully position the bumper to the forward face of one of the pouch bracket mounting tabs (3), as shown in Figure 2 , and press firmly into place. Hold the bumper in position with steady pressure for about one minute to ensure proper adhesion. Repeat with two additional bumpers on the remaining mounting tabs.
Push the exposed screw threads back into the horizontal windshield bracket (5), and pull the vertical windshield supports (6) slightly away from the horizontal bracket to allow the pouch bracket mounting tabs (3) to fit between them.
3. Place the windshield pouch and bracket (2) with the mounting tabs (3) between the horizontal windshield bracket and vertical windshield supports. Push the screws back through the pouch bracket tabs and vertical supports.
4. Fasten the acorn nuts (7) removed in Step 1 onto the screw threads. Tighten the nuts to 10.2–12.4 N·m (90–110 in-lbs).
5. Adjust the windshield position upward if necessary to ensure that the windshield pouches do not rest on handlebar-mounted gauges (if so equipped).
1Rubber bumper (3)
2Windshield pouch
3Pouch bracket mounting tab (3)
5Windshield horizontal inner brace
6Vertical windshield bracket
7Acorn nut
Figure 1. Windshield Pouch Installation, Side View
1Rubber bumper (3)
2Windshield pouch
3Bracket mounting tab (3)
Figure 2. Windshield Pouch, Bottom View
Figure 3. Service Parts, Multi-Pocket Windshield Pouch
Table 1. Service Parts Table
Description (Quantity)
Part Number
Bumper, rubber, 1/2 inch (13 mm) diameter (4 in kit, 3 used this application)
Not sold separately
Multi-pocket windshield pouch
Not sold separately