MEDIA GLOVE BOX LINER KIT
J059212014-03-17
GENERAL
Kit Number
76000539
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Media glove box liner, R.H.
Not Sold Separately
Media glove box liner, L.H.
Not Sold Separately
There are no Service Parts available with this kit.
INSTALLATION
NOTE
The media glove box liners are labeled (Left and Right) for easier identification.
1.
See Figure 1. Open glove box door (A).
2.
Remove the original molded rubber liner glove box (B).
3.
Remove the hook and loop tabs from the inside of the glove box. Discard the hook and loop tabs.
4.
Wipe the inside of the glove box with a clean damp rag or sponge. Allow to dry completely.
5.
Apply pressure on liner (C) surfaces and slide into the glove box. Adjust until liner fits snugly inside glove box.
6.
Close glove box door.
Figure 1. Media Storage Liner, Left Side
7.
See Figure 2. Open glove box door (A).
8.
Remove the original molded rubber liner glove box (B).
9.
Remove the hook and loop tabs from the inside of the glove box. Discard the hook and loop tabs.
10.
Wipe the inside of the glove box with a clean damp rag or sponge. Allow to dry completely.
11.
Hold the communications cable connector (D) to the top of the glove box.
12.
Apply pressure on liner (C) surfaces and slide into the glove box. Adjust until liner fits snugly inside glove box.
13.
Close glove box door.
Figure 2. Media Storage Liner, Right Side