SCREAMIN' EAGLE NIGHTSTICK MUFFLER KIT
J059492013-11-08
GENERAL
Kit Numbers
64900242, 64900243
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Proper installation of this kit requires the separate purchase of one muffler clamp (Part No. 65283-94A).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet refers to service manual information. A service manual for this year/model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
Kit Contents
See Figure 2 and Table 1.
Product Information
Tampering Prohibition
Federal law prohibits any modification to this exhaust system which causes the motorcycle to exceed the Federal noise standard. Use of the motorcycle with such a modified exhaust system is also prohibited.
NOTE
This product should be checked for repair or replacement if the motorcycle noise has increased significantly through use. Otherwise, the owner may become subject to penalties under state and local ordinances.
Noise Emission Warranty
Harley-Davidson warrants that these mufflers, at the time of sale, meet all applicable United States E.P.A. Federal noise and Emissions standards. This warranty extends to the first person who buys these mufflers for proposes other than resale, and to all subsequent buyers. Warranty claims should be directed to an authorized Harley-Davidson Dealer.
INSTALLATION
1.
See Figure 1. Remove two clamps (4) and remove collector shield (5).
2.
Note the clamp (8) orientation and loosen stock muffler clamp.
NOTE
Do not remove flange nut and pin (6). It will slide out as an assembly when the muffler is removed.
3.
Remove and retain stock bolt (1).
4.
Remove stock muffler from the exhaust bracket and head pipe and discard stock muffler clamp. If the rubber isolator (7) pulls out of exhaust bracket, push it back into place.
5.
Place a new muffler clamp on inlet end of muffler in the same orientation as the stock clamp.
6.
Slide muffler onto head pipe while aligning the new pin bracket with the hole in the rubber isolator (7).
7.
Align the holes in the muffler bracket and the exhaust bracket and install the screw (1). Tighten screw to 23–28 N·m (17–21 ft-lbs).
8.
Tighten new muffler clamp (8) to 52–58 N·m (38–43 ft-lbs).
9.
Install the collector shield with clamps (4).
NOTICE
Wipe all fingerprints off of exhaust system components after installation and before starting engine. Oil from hands can leave permanent marks on exhaust system finish. (00346a)
10.
Wipe muffler clean of all fingerprints. Oil from hands will burn permanently into chrome finish.
11.
Start engine and check for exhaust leaks.
12.
Install saddlebags following the instructions in the service manual.
1Screw
2Muffler
3Muffler support
4Clamp (2)
5Collector exhaust shield
6Pin with flange nut
7Rubber isolator
8Muffler clamp
Figure 1. Remove OE Exhaust
SERVICE PARTS
Figure 2. Service Parts: Night Stick Performance Muffler Kit
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
Muffler
Not Sold Separately
2
Collector shield, black
65400174
2
Collector shield, chrome
65400175
Items mentioned in text, but not included in kit:
A
Muffler clamp (purchased separately)
65296-95A