FAT HANDLEBAR KIT
J060012014-04-10
GENERAL
Kit Number
55800386
55800388
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
Separate purchase and installation of Riser Kit (Part No. 55900067) is required for installation of this kit on your model motorcycle. This is available from a Harley-Davidson dealer.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
Kit Contents
This kit contains a handlebar .
INSTALLATION
This handlebar installs in the same manner as the original equipment (OE) handlebar. See the service manual to remove and install the handlebar and risers.
WARNING
Be sure that steering is smooth and free without interference. Interference with steering could result in loss of vehicle control and death or serious injury. (00371a)
  • Riser Kit (Part No. 55900067) must be installed. Follow the instructions supplied with the riser kit.
  • Make sure clutch cable and front brake line do not pull tight when handlebar is turned to left or right fork stops.
  • Make sure hand controls do not touch the fuel tank when turned to left or right fork stops.