Inner Fairing Trim Panels
J058732014-09-29
GENERAL
Kit Number
61400251, 61400283, 61400334
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 2 and Table 1.
INSTALLATION
  • Ambient temperature should be between 21 °C (70 °F) and 38 °C (100 °F) for proper adhesion. Do not apply below 10 °C (50 °F) .
  • Allow AT LEAST 24 hours after application before exposing the area to vigorous washing, strong water spray or extreme weather.
  • The adhesive bond will increase to maximum strength after about 72 hours at normal room temperature.
NOTE
Do not clean with denatured alcohol, mineral spirits or other solvents. Damage to components may occur.
1.
Using a 50:50 isopropyl alcohol/water solution, thoroughly clean the dash panel surfaces surrounding the dash switches and beneath the ignition switch knob. Also clean the surfaces of the media door and its mirror image molded into the left side of the inner fairing.
NOTE
The parts cannot be repositioned after initial installation.
2.
See Figure 1. Get the media door trim panel. With the adhesive backing still in place, position the panel over the media door. Hold the panel in position and apply a small piece of masking tape along its outer edge.
1Tape-Media Door Trim Panel
2Tape-Inner Fairing
3Alignment marking
Figure 1. Media Door Trim Panel Alignment
3.
Apply a second piece of masking tape to the inner fairing next to the first piece of tape.
4.
Draw an alignment mark across both pieces of tape.
5.
Remove the panel and then remove its adhesive backing.
6.
Position the panel by aligning the marks and install the panel to the media door.
7.
Apply firm, sliding pressure across the entire panel to make sure that there is good adhesion to the media door.
8.
Remove the masking tape.
9.
Repeat the same general procedure for all of the parts in the kit.
SERVICE PARTS
Figure 2. Service Parts
Table 1. Service Parts Table
Item
Description (Quantity)
Part Number
1
Ignition switch trim panel
Not Sold Separately
2
Switch trim panel, right side
Not Sold Separately
3
Switch trim panel, left side
Not Sold Separately
4
Media door trim panel
Not Sold Separately
5
Inner fairing trim panel
Not Sold Separately