ENGINE GUARD KITS
J056972013-07-19
GENERAL
Kit Number
49184-09A
Models
This kit fits 2009 and later Touring models.
Additional Parts Required
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
See Figure 1 and Table 1.
Installation
This kit is a direct replacement for the original equipment (OE) engine guard.
2009-2013 Models: See the service manual to remove and install engine guard. Install the upper screw and washer included in this kit instead of the OE screw and washer. Tighten the upper screw to 30–38 N·m (22–28 ft-lbs).
2014 and Later Models: See the service manual to remove and install the engine guard.
SERVICE PARTS
Figure 1. Service Parts: Engine Guard Kit
Table 1. Kit Contents P/N 49050-09A
Item
Description (Quantity)
Part Number
1
Engine guard
Not Sold Separately
2
Washer, ferrous heat treated
6116
3
Hex socket head cap screw
2708A
4
Warning label
14148-86