XL PRIMARY AND CYLINDER BASE COVER KIT
J055282011-12-06
GENERAL
Kit Numbers
25700194, 25700196
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
Kit Contents
Kit includes inner primary cover, cylinder base cover and case bolt. There are no Service Parts available with this kit.
COVER INSTALLATION
1.
See Figure 1. Remove and discard case bolt (1).
2.
Remove the primary fasteners shown (2). Save fasteners for installation.
3.
Place a small bead of silicone around the inside of the empty bolt hole from step 1. Insert the case bolt from kit through the hole in the cylinder base cover and loosely install it in the case.
4.
See Figure 2. Slide the inner edge of the primary cover (1) under the bottom edge of the cylinder base cover (2) and attach it with the fasteners removed in step 2. Tighten fasteners to 10.9 N·m (8 ft-lbs).
5.
Tighten case bolt (3) to 20.4 N·m (15 ft-lbs).
1Case bolt
2Primary fasteners
Figure 1. Remove Fasteners
1Primary cover
2Cylinder base cover
3Case bolt
Figure 2. Primary And Cylinder Base Covers