RIDER BACKREST KIT
J064322025-01-23
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
52300409, 52300745 | Safety Glasses |  |
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Backrest - Rider
Table 2. Kit Contents: Rider Backrest Kits
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Backrest assembly | Not sold separately | |
| 2 | 1 | Screw, button head | Not sold separately | |
| 3 | 1 | Pivot head backrest | Not sold separately | |
| 4 | 1 | Grade 8 Hex cap screw, black | Not sold separately | |
| 5 | 2 | Adjustment knob | 51868-06A | |
| 6 | 1 | Lower mount bracket | Not sold separately | |
| 7 | 4 | Shoulder washer, nylon | Not sold separately | |
| 8 | 1 | Lock nut, stainless steel, black oxide | Not sold separately | |
| 9 | 1 | Upper mount bracket | Not sold separately | |
| 10 | 1 | Lock nut, stainless steel | Not sold separately | |
| 11 | 1 | Adjuster knob cover | 50700055 | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
REMOVE
| 1. | Remove seat. See service manual. | |
| 2. | Remove one side of grab strap. See Service manual. |
INSTALL
| 1. | Figure 2 Feed grab strap through adjuster knob cover. | |
| 2. | Attach grab strap to vehicle. | |
| 3. | Install seat. After installing seat, pull up on seat to verify that it is secure. See service manual. NOTE Rider backrest receptacle can be accessed by separating rider and passenger seat sections by hand. | |
| 4. | With rider backrest folded forward, insert lower mount bracket into receptacle in seat. NOTE A click should be heard when backrest is in the correct position. | |
| 5. | Press rider backrest assembly down until fully seated. |
Figure 2. Adjuster Knob Cover Installed
ADJUSTMENT
| 1. | Raise backrest and adjust as needed for rider comfort. |
NOTE
- Height adjustment knob is loosened to allow sliding up or down of backrest, then tightened to lock in place.
- Forward lean adjustment knob is turned clockwise or counter-clockwise to tilt backrest forward or backward.
| 1 | Height adjustment knob |
| 2 | Forward lean adjustment knob |
Figure 3. Rider Backrest Adjustment Knobs