BLACK SOFTAIL PRIMARY KIT
J067932019-08-21
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
12600257
Safety Glasses, Torque Wrench
1 hour
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Softail Primary Components
Table 2. Kit Contents: Softail Primary Components
Item
Qty
Description
Part No.
Replace
Notes
1
9
Screw
10200942
4813A
Follow torque specification and installation sequence per service manual
2
4
Screw
10200968
10200480
FXBR(S), FLFB(S) and FXDRS models: Not used
Follow torque specification and installation sequence per service manual
10200969
10200481
FXBR(S), FLFB(S) and FXDRS models only
Follow torque specification and installation sequence per service manual
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Ensure you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
INSTALLLATION
Remove and Replace
NOTE
  • See the service manual of the year and model vehicle that the service is being performed on for the following steps.
  • Follow torque specification and installation sequence per service manual for screws.
  • Remove and replace each screw one at a time to maintain initial clamp load.
  • Texture black touch-up pen (98605BF) or bottle (98600BF) can be used for coverage of imperfection on engine covers.
1. Fully remove one Original Equipment (OE) screw.
2. Install new black screw.
3. Tighten screw. See service manual.
4. Repeat steps for remaining screws. Replace screws individually following torque sequence per service manual.