80GRIT™ PASSENGER FOOTPEGS
941000382020-01-14
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
Time
50501603, 50501605
Safety Glasses, Torque Wrench
1 hour
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Footpeg Kit
Table 2. Kit Contents: Footpeg Kit
Item
Qty
Description
Part No.
Notes
1
2
Footpeg assembly, raw
50501619
Kit 50501603
Footpeg assembly, black
50501620
Kit 50501605
2
2
Screw
2708A
28.5 N·m (21.0 ft-lbs)
3
8
Screw
10200913
1.13–1.36 N·m (10–12 in-lbs)
4
2
Footpeg trim
Not sold separately
NOTE
Verify all contents are present in the kit before installing or removing items from vehicle.
GENERAL
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Verify that you are using the most current version of the instruction sheet which is available at: www.harley-davidson.com/isheets.
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
Proper installation of this kit requires Loctite 243 Threadlocker and Sealant - Blue (Part No. 99642-97).
REMOVE
1. Remove hardware fastening existing footpegs to footpeg support. Save hardware for installation. See service manual.
2. Save all hardware for installation of new footpegs.
3. Remove existing footpegs and spring washers. Save spring washers for installation.
INSTALL
1. See Figure 2. Install spring washer (1) as shown and mount end of the footpeg into footpeg support slot (3).
2. Secure each footpeg and spring washer with hardware removed earlier. See service manual.
3. See Figure 1. Adjust orientation:
a. Remove four screws (3) and foot peg trim (4).
b. Loosen screw (2) just enough to allow rotation of footpeg.
c. Rotate to desired orientation.
d. Tighten adjustment screw (2).
Torque: 28.5 N·m (21.0 ft-lbs)
4. Apply a drop of threadlocker to each screw (3).LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)
5. Install trim (4) and four screws (3). Tighten.
Torque: 1.13–1.36 N·m (10–12 in-lbs)
WARNING
Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a)
1Spring washer
2Spring washer straight edge
3Footpeg support slot
Figure 2. Footpeg Spring Washer Installation