Tactical Trekker - Radiator Guard

941000702023-11-10

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾	Time
57200258	Safety Glasses, Torque Wrench		30 minutes

(1) Tightening to torque value or other moderate tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Tactical Trekker - Radiator Guard

Table 2. Kit Contents: Tactical Trekker - Radiator Guard

	Verify that all contents are present in the kit before installing or removing items from vehicle.
	Item	Qty	Description	Part No.	Notes
	1	1	Radiator Guard	Not sold separately
Items mentioned in text, but not included in kit
	A	1	Original Equipment (OE) Radiator
	B	2	OE Screw

GENERAL

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)

NOTE

This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:

A Harley-Davidson dealer.
H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information, see Frequently ask questions about subscriptions.

REMOVE

Figure 2 Remove radiator screws (B).

Figure 2.

INSTALL

Figure 3 Install radiator guard (1) on to radiator.

a. Verify that the radiator is positioned as low as possible.

b. Slightly bend the lower part of the guard, push over the rubber grommets at the bottom of the radiator.

c. Position guard approximately in the middle of the large diameter portion of the radiator grommet at the bottom of the radiator.

Figure 3.

Figure 4 Verify the bottom of the radiator guard is fully seated on the radiator.

Figure 4. Radiator Bottom View

Figure 5 Apply threadlocker to screws (B) and install. Tighten, see the service manual.LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97)

Figure 5.