PASSENGER PILLION
941001902021-08-02
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
52400249 | Safety Glasses |  |
(1) Only simple tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Passenger Pillion
Table 2. Kit Contents: Passenger Pillion
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Seat | Not sold separately | |
| 2 | 1 | Pad | 11100174 | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
REMOVE
| 1. | Figure 2 Insert key in seat lock (2). | |
| 2. | Turn key to release latch (4). | |
| 3. | Lift up then back on passenger seat (3) to remove. | |
| 4. | Lift up then back on rear of rider seat (1) to remove. |
INSTALL
NOTE
Rider seat can be installed in either high position or low position slots to adjust seat height.
| 1. | Figure 3 Insert tabs (3) of new rider seat (1) into high position (4) or low position (5) slots in side covers (2). | |
| 2. | Figure 4 Lower rear of rider seat (1) into position. a. Low Position: Make sure pads (3) rest on frame tubes (4). b. High Position: Make sure seat posts (1) sits in brackets (2). | |
| 3. | Figure 2 Engage tabs on passenger seat (3) in slots of seat support. | |
| 4. | Lower rear of passenger seat. NOTE Apply downward pressure on rear of seat to align. | |
| 5. | Press rear of passenger seat forward and down, aligning pin with latch hole, until a click is heard. | |
| 6. | Pull up on seat to verify it is secure. | |
| 7. | Remove key from seat lock. |
| 1 | Rider seat |
| 2 | Seat lock |
| 3 | Passenger seat |
| 4 | Latch |
Figure 2. Passenger Seat
| 1 | Rider seat |
| 2 | Side cover (2) |
| 3 | Tab (2) |
| 4 | High position |
| 5 | Low position |
Figure 3. Rider Seat
| 1 | Seat post (2) |
| 2 | Bracket (2) |
| 3 | Pad (4) |
| 4 | Tube, frame |
Figure 4. Seat High / Low Positions