LOW PROFILE PASSENGER PILLION

941004542024-01-24

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
52400329, 52400330	Safety Glasses

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Low Profile Passenger Pillion

Table 2. Kit Contents: Low Profile Passenger Pillion

Verify that all contents are present in the kit before installing or removing items from vehicle.
Item	Qty	Description	Part No.	Notes
1	1	Pillion seat	Not sold separately
2	1	Seat screw	10201398
3	1	Passenger grab strap	52400325

GENERAL

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Do not install these seat kits on motorcycles that are not equipped with an appropriate grab strap and passenger footpegs. If footpegs and grab strap are not installed, passenger could fall from moving motorcycle or grab onto operator, causing loss of control and death or serious injury. (00410b)

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:

A Harley-Davidson dealer.
H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.

These items are available at your local Harley-Davidson dealership.

Separate purchase of Low-Profile Solo Touring Seat (Part No. 52000690 or 52000691) is required for installation.
Separate purchase Seat Mount Kit (Part No. 10400077) is required, IF the Original Equipment (OE) seat mounting hardware is not available.

INSTALL

1.	Figure 2 Remove custom nuts (4) and lift rear of solo seat.
2.	Install passenger grab strap (5) onto studs.
3.	Install solo seat over grab strap (5).
4.	Install custom nuts (4). Tighten. Torque: 1–1.7 N·m (9–15 in-lbs) Custom Nut
5.	Install pillion seat (2) through grab strap (5) to seat custom nuts. a. Slide two slots in pillion base into grooves on the custom nuts. b. Verify that tab at front of seat engages the slot.
6.	Secure rear of pillion to fender. a. Position seat tab onto fender nut (3). b. Install seat screw (1). Tighten. Torque: 5.4–8.1 N·m (48–72 in-lbs) Seat Screw
7.	Lift up on pillion and rider seat to ensure it is secure.

1	Seat screw
2	Pillion seat
3	Fender nut
4	Custom nut (2)
5	Passenger grab strap

Figure 2. Pillion Seat Install