Screamin' Eagle Fork Brace Kit
J037542008-12-16
GENERAL
Kit Number
46595-06A
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
1. See Figure 1. Insert the brace between fork tubes. Spread the brace to fit tight to the fork tubes and take note of the spacing. Remove the fork brace and tighten screws (2).
2. Insert the fork brace between the fork tubes and set the desired height from top of the front fender.
3. Install the end caps (3 and 4) using screws (1).
WARNING
Failure to provide adequate clearance between stationary and moving parts can cause loss of control, which could result in death or serious injury. (00378a)
4. Tighten end caps screws (1).
NOTE
It is very important to tighten all screws evenly and carefully to prevent binding.
NOTE
Check clearance between the fork brace and front end components such as brake hoses and cables. Check all clearances throughout the travel range of the front suspension.
SERVICE PARTS
Figure 1. Service Parts: Screamin' Eagle Fork Brace Kit
Table 1. Service Parts: Screamin' Eagle Fork Brace Kit
Item
Description (Quantity)
Part Number
1
Screw, socket head, 1/4-20 x 1/2 inch (4)
94774-99
2
Screw, socket head, 5/16-18 x 1/2 inch (4)
4987
3
End cap, left
Not Sold Separately
4
End cap, right
Not Sold Separately
5
Brace half, left
Not Sold Separately
6
Brace half, right
Not Sold Separately