MOLDED GLOVE BOX LINER KIT
J058952013-10-05
GENERAL
Kit Number
57100270
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Glove box liner, R.H. | Not Sold Separately |
Glove box liner, L.H. | Not Sold Separately |
There are no Service Parts available with this kit.
INSTALLATION
NOTE
The molded glove box liners are labeled (Left and Right) for easier identification.
| 1. | See Figure 1. Open glove box door. |  Figure 1. Push top of door to open |
| 2. | Wash the inside of the glove box with warm, soapy water. Rinse and dry thoroughly. |  Figure 2. Glove Box Door Open  Figure 3. Install Liner into Glove Box (right side shown) |
| 3. | See Figure 3. Compress liner with fingers and press into glove box. | |
| 4. | Apply pressure on liner surfaces until it fits snugly inside glove box. | |
| 5. | Close glove box door. | |
| 6. | Repeat for molded glove box liner on opposite side. |