0/0
H-D SMART SECURITY SYSTEM
J063182022-05-26
GENERAL
Kit Number
41000460, 41000461
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
NOTE
Always disarm the vehicle by turning the IGN ON with the fob present before removing or disconnecting the battery. This prevents the siren (if installed) from activating.
The security system functionality is provided by a Security Control Module (SCM). The SCM will disable the starter and ignition system. Additional functions include the ability to alternately flash the left and right turn signals and sound a siren (if equipped) if a theft attempt is detected.
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet refers to service manual information. A service manual for this year/model motorcycle is required for this installation and is available from a Harley-Davidson dealer.
Installation Requirements
Proper installation of this kit requires the use of the following tool: DIGITAL TECHNICIAN II (Part Number:HD-48650)
Kit Contents
WARNING
Contains button or coin cell battery. Hazardous if swallowed, can result in death or serious injury. (13807a)
See Figure 2 and Table 1.
PREPARATION
WARNING
To prevent accidental vehicle start-up, which could cause death or serious injury, remove main fuse before proceeding. (00251b)
1. Remove main fuse. See service manual.
2. Remove seat. See service manual.
1SCM
2SCM [326]
3Storage clip
4Security antenna connector [209]
5Security antenna
Figure 1. Under Seat
3. See Figure 1. Install SCM (1) and connect the connector (2).
4. Locate security antenna storage clip (3) and remove security antenna connector.
5. Connect security antenna connector (4) to security antenna (5) and install antenna.
6. Install seat. After installing seat, pull up on the seat to verify that it is secure. See service manual.
7. Install main fuse. See service manual.
8. Using Digital Technician II (DT II), program SCM.
SERVICE PARTS
Figure 2. Service Parts
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
SCM (Non-HDI) (1)
SCM (HDI) (1)
41000344
41000374
2
Security system antenna (1)
41000372
3
Security fob (Non-HDI)(1)
Security fob (HDI)(1)
90300117
60300119