FRONT BRAKE ROTOR KIT (320MM)
941004072024-01-23
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
41500212 | Safety Glasses, Torque Wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Front Brake Rotor Kit (320mm)
Table 2. Kit Contents: Front Brake Rotor Kit (320mm)
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 5 | Screw, chrome | Not sold separately | |
| 2 | 1 | Brake rotor, front (320mm) | Not sold separately | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
- Separate purchase of Loctite 243 Medium Strength Threadlocker and Sealant (Part No. 99642-97) is required.
This item is available at your local Harley-Davidson dealership.
REMOVE
| 1. | Remove front wheel. See service manual. | |
| 2. | Remove and discard brake rotor screws. | |
| 3. | Remove and discard brake rotor(s). |
INSTALL
NOTICE
Do not re-use brake disc/rotor screws. Re-using these screws can result in torque loss and damage to brake components. (00319c)
| 1. | Apply a few drops of threadlocker to threads of new chrome screws.LOCTITE 243 MEDIUM STRENGTH THREADLOCKER AND SEALANT (BLUE) (99642-97) | |
| 2. | Position new brake rotor on wheel. See service manual. | |
| 3. | Install screws. Tighten. Torque: 33 N·m (24 ft-lbs) |
COMPLETE
NOTE
Avoid hard stops for the first 300 miles. Hard stops during wear-in period will gall brake discs.
| 1. | Install front wheel. See service manual. |