FORGED CARBON FIBER CONSOLE
941004762024-01-23
GENERAL INFORMATION
Table 1. General Information
Kits | Suggested Tools | Skill Level(1) |
|---|---|---|
70901157 | Safety glasses, Torque wrench |  |
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Console Assembly
Table 2. Kit Contents: Console Kit
 | Verify that all contents are present in the kit before installing or removing items from vehicle. | ||||
|---|---|---|---|---|---|
Item | Qty | Description | Part No. | Notes | |
 | 1 | 1 | Screw | 2856 | |
| 2 | 1 | Fuel gasket | 70900948 | |
| 3 | 1 | Carbon fiber console trim | Not sold separately | |
| 4 | 1 | Screw | 4856 | |
| 5 | 2 | Side gaskets | 70901170 | |
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
- A Harley-Davidson dealer.
- H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.
PREPARE
| 1. | Remove seat assembly. See service manual. | |
| 2. | Remove console. See service manual. |
INSTALL
NOTE
When performing this installation, do not scratch nearby painted or chrome surfaces.
| 1. | Figure 2 Install console (2) using care to keep boot in place around fill tube. | |
| 2. | Install new screw (1) and new screw (3). Tighten. Torque: 4–7 N·m (35–62 in-lbs) Lower screw (3) Torque: 2.3–3.3 N·m (20–29 in-lbs) Upper screw (1) |
| 1 | Screw |
| 2 | Console |
| 3 | Screw |
Figure 2. Console Install
COMPLETE
| 1. | Install seat. After installing seat, pull up on seat to verify that it is secure. See service manual. |
CARE AND MAINTENANCE
Forged Carbon Fiber part is painted with a matte clear coat and it should not be polished as that would cause an irreparable glossy spot on the part and potentially remove the protective top coat.