FLHR (Road King) Headlamp Visor Mounting Kit

J004192014-01-24

GENERAL

Kit Number

67761-96

Models

For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

NOTE

This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.

Kit Contents

Table 1. Kit Contents

Quantity	Description
2	Spring clips
1	Visor mounting pad

No Service Parts are available for this kit.

INSTALLATION

See Figure 1. Attach the headlamp visor mounting pad (3) to the underside of the headlamp visor (1) within approximately 1/16" (1.58mm) (2) of visor lip (4).

NOTE

Your vehicle is already equipped with a headlamp door (trim ring).

1	Headlamp visor
2	1/16" (1.58mm)
3	Headlamp visor mounting pad
4	Visor lip

Figure 1. Visor Mounting Pad Attachment to Visor

Remove headlamp door (trim ring) by removing screw at bottom of headlamp. Do not discard screw.

See Figure 2 and Figure 3. Place a spring clip (1) inside of trim ring (2), on each side of the stock clip, equally spaced as shown.

1	Spring clip
2	Trim ring
3	Stock clips

Figure 2. Spring Clips and Trim Ring

1	Spring clips
2	Top of trim ring
3	Visor lip location

Figure 3. Spring Clip/Visor Placement

Place visor lip between bottom of trim ring and spring clips. Center the visor to the stock clip at top of trim ring.

While holding visor in trim ring, push the trim ring back on headlamp.

Reattach trim ring to headlamp frame with screw removed in step 2.

If necessary, re-aim headlamp. See the Service Manual for detailed procedures.