Axle Cap Nut Kit (Chrome)
J027232007-08-30
GENERAL
Kit Number
45813-03
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
NOTE
A Service Manual for your model motorcycle is available from a Harley-Davidson Dealer.
INSTALLATION
| 1. | Secure the front wheel of the motorcycle. | |||||||||
| 2. | Remove one hex nut, lockwasher and flat washer attaching the axle holder to the right-side fork damper tube. | |||||||||
| 3. | Assemble a chrome flat washer, split lockwasher and cap nut from the kit to the fork damper stud, but do not fully tighten at this time. | |||||||||
| 4. | Repeat with the remaining nut, lockwasher and flat washer on the other stud. | |||||||||
| 5. | For 2000 and later models: See Figure 1. Insert a 7/16 inch drill bit (3) into the hole in the front axle (2). Pull the right-side fork leg (1) so that it just contacts the drill bit. | 
Figure 1. Align the Front Wheel | ||||||||
| 6. | Tighten the new chrome cap nuts (4) to 12–18 N·m (9–13 ft-lbs). |
SERVICE PARTS
Figure 2. Service Parts: Front Axle Cap Nut Kit
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Cap nut, 5/16-18 (chrome) (2) | 8024 |
Lockwasher, split, 5/16 inch (chrome) (2) | 94081-90T |
Washer, flat, 5/16 inch (chrome) (2) | 6330 |