TRI-GLIDE FENDER SCUFF KIT
J051272010-01-29
GENERAL
Kit Number
83976-10
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
There are no service parts available with this kit.
INSTALLATION
| 1. | Clean the fender scuff kit mounting area thoroughly with a solution of equal parts water and isopropyl alcohol. Allow to dry throughly. NOTE The left and right panels are embossed with "Left" and "Right". | |||||||||
| 2. | See Figure 1. Obtain the right fender scuff panel. Do not remove the adhesive tape backing from the panel. | |||||||||
| 3. | See Figure 2. Position the panel (1) approximately 1/4 inch above the leading edge of the fender. | |||||||||
| 4. | See Figure 3. Hold the inner half of the panel (1) in place while removing the adhesive tape backing (2) from the outer half of the panel. | |||||||||
| 5. | Carefully adhere the outer half of the panel to the fender. Press from the inward side to the outward side of the panel to make a firm bond. | |||||||||
| 6. | Remove the adhesive tape backing from the inner half and adhere the inner half to the fender. | |||||||||
| 7. | Repeat for the left side fender scuff panel. | |||||||||
| 8. | Allow AT LEAST 24 hours after applying the scuff panels before operating vehicle or exposing the area to vigorous washing, strong water spray or extreme weather. | 
Figure 1. Fender Scuff Panels 
Figure 2. Fender Scuff Panel Positioning 
Figure 3. Removing Adhesive Tape Backing |