DYNA JIFFY STAND EXTENSION

J054162011-04-15

GENERAL

Kit Number

50000032

Models

For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).

WARNING

Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)

Kit Contents

See Figure 2 and Table 1.

INSTALLATION

1.	See Figure 1. Check the condition of jiffy stand end wire (2) and bumper (1). The end wire must be parallel to the end of the jiffy stand and in good condition. The bumper attached to the frame must be in place and in the proper orientation.
2.	See Figure 2. Install jiffy stand extension (1) on to end wire of jiffy stand as shown.
3.	Install the extension in place with the clamp (3), screw (2) and locknut (4). Adjust position of extension until a comfortable rider position is located.
4.	Tighten locknut to 96 N·m (8 ft-lbs).
5.	Check jiffy stand and extension for unrestricted movement through the normal range of travel. NOTE Do not step on jiffy stand extension or it may be damaged.

1	Bumper
2	End wire

Figure 1. End Wire and Bumper

SERVICE PARTS

Figure 2. Service Parts: Jiffy Stand Extension

Table 1. Service Parts

Item	Description (Quantity)	Part Number
1	Jiffy stand extension	Not Sold Separately
2	Bolt	94387-92T
3	Clamp	Not Sold Separately
4	Locknut	7671
Items mentioned in text, but not included in kit.
A	Jiffy stand