FRONT FENDER SKIRT KIT
J060792015-08-04
GENERAL
Kit Numbers
61400311, 61400312
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
INSTALLATION
Replacement Skirt Installation
| 1. | See Figure 2. Remove screws, washers and nuts securing existing fender skirt to fender. Discard fender skirt and hardware. | |
| 2. | Clean the fender in the skirt mounting area with a mixture of 50 percent isopropyl alcohol and 50 percent distilled water. Allow to dry completely. NOTE Install the new washers on the inside of the fender. | |
| 3. | Get the new fender skirt (1), fender skirt mounting screws (2), washers (3) and nuts (4) from the kit. Align the fender skirt as shown. Install skirt to fender, but do not fully tighten. Follow the tightening sequence in Figure 2 inset. Press the fender skirt firmly against the fender at each hole in turn while tightening the mounting hardware to 1.1–1.7 N·m (10–15 in-lbs). |
Clean Fender Installation
WARNINGDo not contact tire with drill bit when drilling fender holes. Drill bit contact with tire can lead to premature tire failure, which could result in death or serious injury. (00403f)
NOTE
To install this skirt kit on a Clean Front Fender, perform the following:
| 1. | Clean the fender in the skirt mounting area with a mixture of 50 percent isopropyl alcohol and 50 percent distilled water. Allow to dry completely. | |
| 2. | See Figure 1. Cover that portion of fender with masking tape to protect painted surface during positioning of skirt and drilling of mounting holes (1). |  Figure 1. Clean Front Fender Hole Locations |
| 3. | Place fender skirt in desired location and mark mounting hole locations with felt tip pen. Align the lower edge of the fender skirt parallel to, but slightly below the lower edge of the fender. | |
| 4. | Remove fender skirt. Carefully center punch holes at marked locations. | |
| 5. | Drill mounting holes using a 3 mm (⅛ in) diameter drill bit. | |
| 6. | Remove masking tape. Attach fender skirt as described under Replacement Skirt Installation, Step 3. |
SERVICE PARTS
Figure 2. Service Parts: Front Fender Skirt, Chrome or Black
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Skirt, front fender | Not sold separately |
2 | Machine screw, pan head, #4-40 x 8 mm (0.31 in) long, stainless steel (6) | Not sold separately |
3 | Flat washer, #4, stainless steel (6) | Not sold separately |
4 | Hex nut, Nyloc, #4-40, stainless steel (6) | Not sold separately |