0/0
WOUNDED WARRIOR FLAG KIT: TOUR-PAK & HARD SADDLEBAGS
J062492015-03-15
GENERAL
Kit Number
61400377
Models
This kit fits all motorcycle models equipped with a Tour-Pak® or hard saddlebags.
NOTE
Flags are not intended for highway use. The construction of these flags will not hold up to the wind speeds at highway speeds. These flags are designed for parade use only.
Kit Contents
Table 1. Kit Contents
Description (Quantity)
Part Number
Wear pads (2)
94620-98
Flag mast
Not Sold Separately
Flag mast retainer
Not Sold Separately
Rubber pad
61079-82
Flag
61400376
There are no Service Parts available with this kit.
INSTALLATION
NOTE
Water may enter Tour-Paks/saddlebags with flag mast installed during inclement weather.
NOTE
Attaching a flag mast to a Tour-Pak or saddlebag without wear pads in place may result in damage to the Tour-Pak or saddlebag exterior. Periodically check to verify the flag mast remains in contact with wear pads.
  1. See Figure 1. Remove the adhesive backing from the wear pads and fasten them where the mast base contacts the painted Tour-Pak or saddlebag.
  2. Fasten the flag mast bracket over the pads on the Tour-Pak or saddlebag as shown.
    3. NOTE
    Attaching flag mast to Tour-Pak or saddlebag without rubber pads in place may result in damage to exterior of Tour-Pak or saddlebag.
  3. Cut the self-adhesive rubber pad in half.
  4. Remove the adhesive backing from the rubber pads.
  5. See Figure 2. To stabilize the flag mast laterally, place on pad on either side of the flag mast bracket on the inside of the Tour-Pak or saddlebags.
1Wear Pad
Figure 1. Flag Mast and Wear Pads on Tour-Pak
1Rubber Pads
Figure 2. Rubber Pads Installed on Tour-Pak Interior