HIGH FLOW PERFORMANCE INJECTOR KIT
J065232016-11-23
GENERAL
Kit Number
27400040
Models
For model fitment information, see the Screamin' Eagle® Pro Racing Parts catalog.
This kit will only fit on Milwaukee-Eight models if they are equipped with the following Screamin' Eagle accessories:
- Kit 27200040 64 mm throttle body.
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation. One is available from a Harley-Davidson Dealer.
Kit Contents
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Fuel injector assembly, 5.5 g/s flow rate (2) | 27400039 |
INSTALLATION
WARNINGWhen servicing the fuel system, do not smoke or allow open flame or sparks in the vicinity. Gasoline is extremely flammable and highly explosive, which could result in death or serious injury. (00330a)
- Refer to the owner's manual to locate and remove the main fuse.
- Refer to the service manual for your motorcycle for fuel injector replacement. Refer to FUEL INJECTION, Fuel Rail/Fuel Injectors of the applicable service manual for instructions.
Calibrate the ECM
NOTICE
You must recalibrate the ECM when installing this kit. Failure to properly recalibrate the ECM can result in severe engine damage. (00399b)
- Recalibrate ECM with proper calibration for configuration. See Dealer for details.
- Start and run engine. Repeat several times to verify proper operation.