DOMINION PILLION (FXFB)
J066702019-01-15
GENERAL
Kit Number
52400197
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Installation Requirements
WARNINGRider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
WARNINGDo not install these seat kits on motorcycles that are not equipped with an appropriate grab strap and passenger footpegs. If footpegs and grab strap are not installed, passenger could fall from moving motorcycle or grab onto operator, causing loss of control and death or serious injury. (00410b)
REMOVAL
| 1. | Remove solo seat. See owner's manual. |
INSTALLATION
| 1. | See Figure 1. Install fender seat nut assembly. a. Under the fender: Align and install nut (2) into cutout. b. Top of fender: Install clip (1) to nut (2). | |
| 2. | NOTE Make sure that the folds of the grab straps are installed facing inward. | |
| 3. | Install washer (2) and screw (3). Tighten. Torque: 6.8–10 N·m (60–89 in-lbs) Grab strap screw | |
| 4. | See Figure 3. Install solo seat. a. Secure rider seat rear mounting tab (4) onto fender. b. Install spool mount (3) and screw (2). Tighten. Torque: 1.8–3.4 N·m (16–30 in-lbs) Spool mount screw c. Position grab strap over seat. | |
| 5. | See Figure 4. Install passenger pillion (2). a. Connect front seat tab of pillion to spool mount. b. Position grab strap (1) over pillion. c. Install thumb screw (3). | |
| 6. | Pull up on seat and pillion to check that it is secure. |
| 1 | Fender clip (2) |
| 2 | Fender nut (2) |
Figure 1. Fender Clip and Nut
| 1 | Grab strap |
| 2 | Washer |
| 3 | Screw |
Figure 2. Grab Strap
| 1 | Grab strap |
| 2 | Screw |
| 3 | Spool mount |
| 4 | Rider seat rear mounting tab |
Figure 3. Solo Seat
| 1 | Grab strap |
| 2 | Passenger pillion |
| 3 | Thumb screw |
Figure 4. Pillion Seat
SERVICE PARTS
Figure 5. Service Parts: FXFB Passenger Pillion Kit
Table 1. Service Parts Table
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Passenger pillion seat | Not Sold Separately |
2 | Flatwasher | 6036 |
3 | Grab strap | 52400215 |
4 | Torx™ Socket head screw | 942 |
5 | Passenger seat mount spool | 52400239 |
6 | Fender clip (2) | 59768-97 |
7 | Fender nut (2) | 59768-97 |
8 | Passenger pillion seat | Not Sold Separately |