REAR BRAKE LEVER
941001052023-08-14
GENERAL INFORMATION
Table 1. General Information
Kits
Suggested Tools
Skill Level(1)
41600326, 41600348, 41600370
Safety glasses, Torque wrench
(1) Tightening to torque value or other moderate tools and techniques required
KIT CONTENTS
Figure 1. Kit Contents: Rear Brake Lever
Table 2. Kit Contents: Rear Brake Lever Kit
Verify that all contents are present in the kit before installing or removing items from vehicle.
Item
Qty
Description
Part No.
Notes
1
1
Rear brake lever
Not sold separately
Items mentioned in text, but not included in kit
A
1
B
1
OE washer
C
1
OE clevis pin
GENERAL
Models
For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.
Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets
Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.
Installation Requirements
WARNING
Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:
PREPARE
If removing right side footrest bracket or brake pedal
1. Remove main fuse. See service manual.
2. Remove exhaust. See service manual.
3. Remove footpeg assembly. See service manual.
4. Remove rear brake master cylinder from bracket. See service manual.
5. Remove brake pedal. See service manual.
REMOVE
1. Remove OE brake lever. See service manual.
INSTALL
1. See Figure 1. Install new brake lever (1).
a. Install OE clevis pin (C).
b. Install OE screw (A) and washer (B). Tighten.
Torque: 17–21 N·m (13–15 ft-lbs)
c. 41600348, 41600370: Requires separate purchase of brake pedal pad.
COMPLETE
If right side footrest bracket or brake pedal was removed
1. Install brake pedal. See service manual.
2. Install rear brake master cylinder on bracket. See service manual.
3. Install footpeg assembly. See service manual.
4. Install exhaust system. See service manual.
5. Install main fuse. See service manual.