FLAT-OUT BAR

941004532024-01-23

GENERAL INFORMATION

Table 1. General Information

Kits	Suggested Tools	Skill Level⁽¹⁾
49000255	Safety Glasses, Torque Wrench

(1) Only simple tools and techniques required

KIT CONTENTS

Figure 1. Kit Contents: Flat-Out Bar

Table 2. Kit Contents: Flat-Out Bar

Verify that all contents are present in the kit before installing or removing items from vehicle.
Item	Qty	Description	Part No.	Notes
1	2	Screw, button head	Not sold separately
2	2	Bumper	Not sold separately
3	1	Flat-out bar	Not sold separately	DO NOT use Flat-Out Bar as a tie-down or anchor point.
4	2	Screw, socket head	10201412
5	2	Service kit	49000262	Includes items: screw (1) and bumper (2)

GENERAL

Models

For model fitment information, see the Parts and Accessories (P&A) Retail Catalog or the Parts and Accessories section of www.harley-davidson.com.

Verify that the most current version of the instruction sheet is used. It is available at: h-d.com/isheets

Contact Harley-Davidson Customer Support Center at 1-800-258-2464 (U.S. only) or 1-414-343-4056.

Installation Requirements

WARNING

Rider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)

NOTE

This instruction sheet references service manual information. A service manual for the year and model motorcycle is required for this installation and is available from:

A Harley-Davidson dealer.
H-D Service Information Portal, a subscription-based access available for most 2001 and newer models. For more information see Frequently ask questions about subscriptions.

INSTALL

WARNING

If Equipped: Front and/or rear guards are not intended to provide protection from bodily injury in a collision with another vehicle or any other object. (00022d)

NOTE

DO NOT use Flat-Out Bar as a tie-down or anchor point.

1.	Figure 1 Install bumpers (2) and screws (1) to bar (3). Tighten. Torque: 23–26 N·m (17–19 ft-lbs)
2.	Figure 2 Position flat-out bar (1) to vehicle.
3.	Loosely install socket head screws (2).
4.	Tighten screws (2). Torque: 60.5 N·m (45 ft-lbs)

1	Flat-out bar
2	Screw (2)

Figure 2.

SERVICE

NOTE

Service kit has enough components for one side to be replaced.

Check flat-out bar for damage prior to replacing bumper. Replace as needed.

1.	Figure 3 Remove and discard screw (1) and bumper (2).
2.	Install bumper (2).
3.	Install screw (1). Tighten. Torque: 23–26 N·m (17–19 ft-lbs)

1	Screw (1)
2	Bumper (1)

Figure 3.