1. | Remove solo seat. See owner's manual. |
1. | See Figure 1. Install fender seat nut assembly. a. Under the fender: Align and install nut (2) into cutout. b. Top of fender: Install clip (1) to nut (2). | |
2. | NOTE Make sure that the folds of the grab straps are installed facing inward. | |
3. | Install washer (2) and screw (3). Tighten. Torque: 6.8–10 N·m (60–89 in-lbs) Grab strap screw | |
4. | See Figure 3. Install solo seat. a. Secure rider seat rear mounting tab (4) onto fender. b. Install spool mount (3) and screw (2). Tighten. Torque: 1.8–3.4 N·m (16–30 in-lbs) Spool mount screw c. Position grab strap over seat. | |
5. | See Figure 4. Install passenger pillion (2). a. Connect front seat tab of pillion to spool mount. b. Position grab strap (1) over pillion. c. Install thumb screw (3). | |
6. | Pull up on seat and pillion to check that it is secure. |
1 | Fender clip (2) |
2 | Fender nut (2) |
1 | Grab strap |
2 | Washer |
3 | Screw |
1 | Grab strap |
2 | Screw |
3 | Spool mount |
4 | Rider seat rear mounting tab |
1 | Grab strap |
2 | Passenger pillion |
3 | Thumb screw |
Item | Description (Quantity) | Part Number |
---|---|---|
1 | Passenger pillion seat | Not Sold Separately |
2 | Flatwasher | 6036 |
3 | Grab strap | 52400215 |
4 | Torx™ Socket head screw | 942 |
5 | Passenger seat mount spool | 52400239 |
6 | Fender clip (2) | 59768-97 |
7 | Fender nut (2) | 59768-97 |
8 | Passenger pillion seat | Not Sold Separately |