ENGINE-GUARD FOOTPEG MOUNTING KIT
J011732003-03-06
GENERAL
Kit Number
50964-98
Models
These footpeg mountings fit all H-D 1-1/4 in. diameter front engine guards except VRSC models.
Kit Contents
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Three-piece clamp (2) | 50903-85T |
Large diameter screw (2) | 2348 |
Lockwasher (2) | 7068 |
Footpeg support kit consisting of: | 50900-72TA |
Footpeg mount (2) | Not Sold Separately |
Small diameter screw (2) | Not Sold Separately |
Spring washer (2) | 50912-72 |
Lock nut (2) | Not Sold Separately |
INSTALLATION
WARNINGPosition footpegs so rider can operate foot controls without interference. Failure to have full access to foot controls can cause loss of control, which could result in death or serious injury. (00313a)
| 1. | Remove the four small buttonhead screws that hold the 3-piece clamp (1) together. Place the clamp around the engine guard, positioning the clamp on the straight, upright section of the guard. Re-install the buttonhead screws and torque to 1 N·m (9 in-lbs). | |||||||||||||||||
| 2. | See Figure 1. Pull the 3-piece clamp tabs together with a clamp, or clamping pliers, and install the large diameter screw (2), lockwasher (3), and footpeg mount (5) as shown. Hand-tighten the screw at this time. Repeat for the opposite footpeg mount. | 
Figure 1. Footpeg Mounting Kit Installation (Footpeg Not Shown) | ||||||||||||||||
| WARNING Footrests must fold up and toward rear of motorcycle if struck. Failure to set footrests to fold up and back could result in death or serious injury. (00366a) | ||||||||||||||||||
| 3. | Install the footpegs (purchased separately) using the small diameter screws (6), spring washers (7) and locknuts (8) included in this kit. Make sure the spring washer is positioned inside the footpeg mount with the square edge towards the inside of the mount. Hand tighten the locknuts at this time. | |||||||||||||||||
| 4. | Rotate the footpegs so they fold upward and to the rear, then torque the screws (2) to 64 N·m (47 ft-lbs). | |||||||||||||||||
| 5. | Torque the locknuts (8) to 26 N·m (19 ft-lbs). |
IN USE
WARNINGIf footpeg mounting location increases motorcycle width, maintain clearance between motorcycle and surrounding persons or objects. Failure to maintain clearance could result in death or serious injury. (00314a)