Triple Clamp Cover Moulding Kit
J017092006-11-01
GENERAL
Kit Number
67891-99
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
This kit is designed to be used with Chrome Fork Cover Kit, Part Number 67890-91A.
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
A Service Manual for your model motorcycle is available from a Harley-Davidson Dealer.
Kit Contents
Table 1. Kit Contents
Description (Quantity) | Part Number |
|---|---|
Chrome triple-clamp cover moulding (2) | Not Sold Separately |
Chrome cap screw | Not Sold Separately |
There are no Service Parts available with this kit.
INSTALLATION
| 1. | See Figure 1. Remove the screws fastening the stock moulding to the triple-clamp cover (3). | |
| 2. | Fasten the new moulding (1) to the triple-clamp cover as shown. Tighten the screws (2) until snug. |  Figure 1. Triple clamp moulding |