0/0
SOFTAIL REAR AXLE NUT COVER KIT
J024512007-08-10
GENERAL
Kit Number
44254-01, 44255-01, 44256-01
Models
For model fitment information, please see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
This instruction sheet references Service Manual information. A Service Manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Kit Contents
See Figure 1 and Table 1.
INSTALLATION
NOTE
Inside each axle nut cover is a LH or RH inscription for the left-hand and right-hand side of the vehicle to which the covers fasten.
The shorter axle nut cover mounts on the right-hand side of the vehicle, and the longer cover on the left.
On a bike that has been previously serviced, check to ensure that the axle has not been removed and re-installed from the left side (with the castle nut on the right side of the wheel).
If it has, the axle MUST be re-installed from the right side of the motorcycle. See REAR WHEEL: REMOVAL and INSTALLATION in the Service Manual for procedure.
1. See Figure 1. Partially install a set screw (3) into the threaded hole in each axle nut cover (1, 2).
2. Position each axle nut cover over the appropriate axle nut. The notch in each cover fits over the axle-adjusting screw.
3. Adjust the position of the exhaust system as necessary to provide axle nut clearance.
4. Tighten the axle nut-cover set screws (3) to 7–9 N·m (70 in-lbs).
NOTE
The set screws in this kit are treated with a thread-locking compound. When replacing or re-installing the set screws, apply Loctite® 243 (Blue) Threadlocker (Harley-Davidson Part Number 99642-97) to the set screw threads.
SERVICE PARTS
Figure 1. Service Parts: Softail Rear Axle Nut Cover Kit
Table 1. Service Parts: Softail Rear Axle-Nut Cover Kit
Item
Description (Quantity)
Part Number
1
Axle-nut cover, right side
Not Sold Separately
2
Axle-nut cover, left side
Not Sold Separately
3
Set screw, 1/4-20 x 1/4 inch (2)
3234W