TOURING MUFFLER KIT
J042622011-01-20
GENERAL
Kit Number
80677-08, 80721-09, 80742-09, 80847-10, 64900091, 64900093
Models
For the most up-to-date model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Additional Parts Required
Proper installation of these kits requires the separate purchase of two muffler clamps, Harley-Davidson Part Number 65296-95A.
WARNINGRider and passenger safety depend upon the correct installation of this kit. Use the appropriate service manual procedures. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00333b)
NOTE
This instruction sheet references service manual information. A service manual for your model motorcycle is required for this installation and is available from a Harley-Davidson Dealer.
Product Information
Tampering Prohibition
Federal law prohibits any modification to this exhaust system which causes the motorcycle to exceed the Federal noise standard. Use of the motorcycle with such a modified exhaust system is also prohibited.
NOTE
This product should be checked for repair or replacement if the motorcycle noise has increased significantly through use. Otherwise, the owner may become subject to penalties under state and local ordinances.
Noise Emission Warranty
Harley-Davidson warrants that these mufflers, at the time of sale, meet all applicable United States E.P.A. Federal noise and Emissions standards. This warranty extends to the first person who buys these mufflers for proposes other than resale, and to all subsequent buyers. Warranty claims should be directed to an authorized Harley-Davidson Dealer.
INSTALLATION
| 1 | Muffler clamp |
Figure 1. Front Muffler Clamp
| 1 | Bolt, 5/16-18 x 5/8 inch (4) |
| 2 | Lockwasher (4) |
| 3 | Rubber mount |
Figure 2. Rear Muffler Mount
| 1. | Remove saddlebags according to service manual instructions. | |
| 2. | See Figure 1. Loosen stock muffler clamp (1). | |
| 3. | See Figure 2. Remove and retain stock bolts (1), lockwashers (2) and rubber mount (3). | |
| 4. | Remove stock muffler. Discard clamp from Step 2. | |
| 5. | Place a new muffler clamp on inlet end of muffler and slide muffler onto exhaust pipe. | |
| 6. | Secure rear of muffler to sliding bracket with original equipment bolts and lockwashers. Do not tighten bolts. | |
| 7. | Position sliding bracket so rubber mount is at center of sliding bracket. | |
| 8. | Tighten bolts (1) to 25.7 N·m (19 ft-lbs). | |
| 9. | See Figure 1. Position the muffler clamp as shown. The clamp bolt should be vertical. | |
| 10. | Tighten clamp bolt to 61–81 N·m (45–60 ft-lbs). | |
NOTICE Wipe all fingerprints off of exhaust system components after installation and before starting engine. Oil from hands can leave permanent marks on exhaust system finish. (00346a) | ||
| 11. | Wipe muffler clean of all fingerprints. Oil from hands will burn permanently into chrome finish. | |
| 12. | Repeat Steps 2 through 11 for opposite side. | |
| 13. | Start engine and check for exhaust leaks. | |
| 14. | Install saddlebags according to service manual instructions. |
SERVICE PARTS
Figure 3. Service Parts:Touring Mufflers
Table 1. Service Parts: Touring Mufflers
Kit | Item | Description (Quantity) | Part Number |
|---|---|---|---|
80677-08 | 1 | Muffler, Slash Down, chrome, RH | Not Sold Separately |
2 | Muffler, Slash Down, chrome, LH | Not Sold Separately | |
80721-09 | 1 | Muffler, Slash Down, chrome, RH | Not Sold Separately |
2 | Muffler, Slash Down, chrome, LH | Not Sold Separately | |
80742-09 | 1 | Muffler, Slash Down, black, RH | Not Sold Separately |
2 | Muffler, Slash Down, black, LH | Not Sold Separately | |
80847-10 | 1 | Muffler, Slash Down, black, RH | Not Sold Separately |
2 | Muffler, Slash Down, black, LH | Not Sold Separately | |
64900091 | 3 | Muffler, Dual NightStick, black, RH | Not Sold Separately |
4 | Muffler, Dual NightStick, black, LH | Not Sold Separately | |
64900093 | 3 | Muffler, Dual NightStick, Chrome, RH | Not Sold Separately |
4 | Muffler, Dual NightStick, Chrome, LH | Not Sold Separately | |
Items mentioned in text, but not included in kit: | |||
A | Capscrew, hex (4) | 2882W | |
B | Lock washer (4) | 7041 | |
C | Muffler clamp (2) (purchase separately) | 65296-95A | |