0/0
FENDER STRUT COVERS, GLOSS BLACK
J048922008-12-10
GENERAL
Kit Number
47498-09
Models
For model fitment information, see the P&A Retail Catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
See Figure 1 and Table 1.
There are no Service Parts available with this kit.
INSTALLATION
1. See Figure 1 and Table 1. Remove the saddlebag by opening the lid and turning the two bail head studs 1/4 turn and remove the studs, washers and grommets.
2. Remove the screw (A) and washer (B) from the grab strap (C) and front saddlebag bracket (D).
3. Remove the rear screw (E) and strut cover from the frame.
4. Repeat steps 1-3 for the opposite side.
5. Reverse steps 1-3 for installation of the new kit strut covers (1 and 2).
6. Tighten the rear strut cover screw to 20–27 N·m (15–20 ft-lbs). Tighten the frame screw for the grab strap and saddlebag bracket to 16–20 N·m (12–15 ft-lbs).
Figure 1. Remove/Install Fender Strut Covers
Table 1. Kit Contents
Item
Description (Quantity)
Part Number
1
Fender strut cover, gloss black, right
Not Sold Separately
2
Fender strut cover, gloss black, left
Not Sold Separately