See Figure 5 and Table 1. Assemble the wall storage rack using rods at all four corners.

Use a level to draw a line across the studs where the rack will be mounted. Hold the rack up to the line to mark where the mounting holes will be. You may want to use a drill and a small drill bit to drill pilot holes for the lag bolts (7).

Mount the rack using the lag bolts.

The Detach Depot has been designed to accommodate up to three accessories at once. One accessory on the top, one on the bottom and one windshield on the front (facing down).

The adjustable rods can be mounted to any open slot on the sideplates. Configure the adjustable rods in a manner that best suits your particular accessories. One rod may be used to attach two different detachables. See Figure 5. Mount the adjustable rods to the sideplates using a washer (1) and screw (5) on each side. You may need to readjust the rods a few times in order to get the configuration correct for first time use. Once the rods are in their proper location, cover the screws with decorative end caps (6).

See Figure 2. Quick Release style windshields require separate purchase of a mount kit. The windshields attach to adjustable tubes oriented vertically and in parallel on the front rods.

See Figure 3. Sport Tour-Paks and sissybars can be mounted directly to the rods of the Wall Rack.

See Figure 4. Detachable style windshields (Softail Heritage and Road King Classic) can be mounted directly to the rods on the front side of the wall rack.

See Figure 2 and Figure 5. Rider Backrests require separate purchase of a mount kit (8). The mount attaches to the bottom slot on the sideplates.