TOURING PILLION
J054362023-09-15
GENERAL
Kit Number
52400040, 52400140, 52400141
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
WARNINGDo not install these seat kits on motorcycles that are not equipped with an appropriate grab strap and passenger footpegs. If footpegs and grab strap are not installed, passenger could fall from moving motorcycle or grab onto operator, causing loss of control and death or serious injury. (00410b)
WARNINGRider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
INSTALLATION
Install Pillion
| 1. | See Figure 1. If installed, remove seat mounting nuts (B) and solo seat (A). | |
| 2. | Install grab strap (2) onto the studs where seat mounting nuts were removed. | |
| 3. | Install solo seat (A) and seat mounting nuts (B) over the grab straps. | |
| 4. | Install touring pillion, through the grab strap (2), to the seat mounting nuts: a. Slide two slots in pillion base into grooves on the seat mounting nuts. b. Verify that tab at front of seat engages the slot. NOTE If original equipment (OE) seat mounting hardware is unavailable, a Detachable Seat Hardware Kit (Part No. 51676-97A) is available for separate purchase. | |
| 5. | Secure rear of pillion to the fender using the seat mounting hardware (C) from the OE two-up seat. Lift up on seat to ensure it is secure. |
Remove Pillion
| 1. | See Figure 1. Remove seat mounting hardware (C) at rear of pillion. | |
| 2. | Pull pillion (1) to the rear to disengage from seat mounting nuts. | |
| 3. | If necessary, remove seat mounting nuts (B) and solo seat (A). Remove grab strap (2). | |
| 4. | Install solo seat and seat mounting nuts over studs. Verify that tab at front of seat engages slot in frame. Lift up on seat to ensure it is secure. | |
| 5. | Cover seat mounting nuts with leather flap at rear of seat. | |
| 6. | Remove chrome cap (4) from bottom of pillion. Install cap into pillion mounting hole in fender. |
SERVICE PARTS
Figure 1. Service Parts: Touring Pillion
Table 1. Service Parts
Item | Description (Quantity) | Part Number |
|---|---|---|
1 | Pillion | Not sold separately |
2 | Grab strap (for Kit 52400040) Grab strap (for Kit 52400140) Grab strap (for Kit 52400141) | 52400027 52400036 52400035 |
3 | Cap, plastic (chrome) | 762 |
4 | Screw, TORX, (2) | 941 |
5 | Bracket, seat mounting | 51652-97A |
Items mentioned in text, but not included in kit. | ||
A | Solo seat | |
B | Seat mounting nut (2) | 3633 |
C | Seat mounting hardware | 51676-97A |