0/0
PRIMARY COVER TRIM KIT
J059052018-01-16
GENERAL
Kit Numbers
25600033, 25600034, 25600035, 25600044, 25800089, 25800100
Models
For model fitment information, see the P&A retail catalog or the Parts and Accessories section of www.harley-davidson.com (English only).
Kit Contents
This kit contains one cover trim, one bracket, two screws and these instructions. See Table 1 and Figure 1.
INSTALLATION
NOTE
  • Make sure that ambient temperature is at least 7 °C (45 °F) for proper adhesion.
  • Allow AT LEAST 24 hours after application before exposing the area to vigorous washing, strong water spray or extreme weather.
  • The adhesive bond will increase to maximum strength after about 72 hours at normal room temperature.
1. Clean with a 50-50 mixture of isopropyl alcohol and distilled water. Allow to dry completely.
2. See Figure 1. Test-fit the bracket (3) before removing the protective backing from the tape. The cutout fits over the Bar & Shield logo (A).
3. Remove the protective backing from the tape. Install the bracket. Hold in place for 30 seconds.
4. Secure the trim with two screws (1). Tighten to:
Torque: 3.4–4.2 N·m (30–37 in-lbs) Trim screws
CARE AND CLEANING GUIDELINES FOR BRASS PARTS
Cleaning Instructions
  1. Verify part is dry and free of dirt or debris.
  2. Place a small amount of Harley-Davidson® Chrome Clean & Shine on a microfiber cloth or detailing swab.
  3. Using light pressure, rub the brass parts with the microfiber cloth. For hard to reach places or grooves, use the detailing swab.
Obtaining a Bright Finish
Brass parts will naturally age and darken with time. If a bright brass finish is preferred, place some Harley-Davidson Bare Metal Polish on a microfiber cloth and lightly rub on the brass parts until they reach the desired brightness.
Slowing the Natural Aging Process
To slow the aging process of the brass parts, place a small amount of Harley-Davidson Glaze Poly Sealant on a microfiber cloth or detailing swab, and lightly rub on the parts until the sealant has soaked in.
Precautions
  • Use of non-recommended cleaning, polishing and protective products will result in the removal of the aged finish from the brass parts.
  • Prolonged contact with certain items (hands, gloves, boots, dust, etc.) and exposure to the elements will also alter all surface finishes and is NOT considered a defect.
  • Avoid cleaning parts with abrasive and aggressive chemicals and abrasive cleaning pads.
  • Avoid ammoniated products and bleach.
  • Prolonged exposure to water will alter the brass finish. Wipe down parts after contact with water.
  • Excess rubbing may lighten the surface appearance of the part.
SERVICE PARTS
Figure 1. Service Parts: Primary Cover Trim Kit
Table 1.
Item
Description (Quantity)
Part
Number
1
Button head cap screw, Torx (2) (Kits 25600033, 25600034, 25600035, 25600044)
94590-98
Button head cap screw, Torx (2) (Kits 25800089, 25800100)
10200435
2
Cover trim (Kits 25600033, 25600034, 25600035, 25600044, 25800089)
94590-98
Cover trim (Kit 25800100)
25800099
3
Bracket (Kits 25600033, 25600034, 25600035, 25600044, 25800089)
25600036
Bracket (Kit 25800100)
25600043
Items mentioned in text, but not included in kit:
A
Bar & Shield logo on primary cover