0/0
SAE 2-PIN Y-HARNESS
J061222014-11-01
GENERAL
Kit Number
69201150
WARNING
Rider and passenger safety depend upon the correct installation of this kit. If the procedure is not within your capabilities or you do not have the correct tools, have a Harley-Davidson dealer perform the installation. Improper installation of this kit could result in death or serious injury. (00308b)
WARNING
When installing any electrical accessory, be certain not to exceed the maximum amperage rating of the fuse or circuit breaker protecting the affected circuit being modified. Exceeding the maximum amperage can lead to electrical failures, which could result in death or serious injury. (00310a)
Electrical Overload
NOTICE
It is possible to overload the vehicle's charging system by adding too many electrical accessories. If the combined electrical accessories operating at any one time consume more electrical current than the vehicle's charging system can produce, the electrical consumption can discharge the battery and cause damage to the vehicle's electrical system. (00211d)
WARNING
When installing any electrical accessory, be certain not to exceed the maximum amperage rating of the fuse or circuit breaker protecting the affected circuit being modified. Exceeding the maximum amperage can lead to electrical failures, which could result in death or serious injury. (00310a)
The power outlet itself does not use any additional current. Verify the current draw of any item connected to it does not exceed the capacity of the vehicle electrical system.
Kit Contents
See Figure 3 and Table 1.
Installation
1. Remove the left side cover.
2. See Figure 1. Locate the battery tender connector (1) under the left side cover.
NOTE
Connect the input connector into the tender connector only. Connecting an output connector to the tender connector can damage a device.
1Battery tender connector
2Route connector through slot
Figure 1. Battery Tender Connector
3. See Figure 2. Connect input connector (3) into battery tender connector (5).
4. Connect device or battery tender into the output connectors (4).
1SAE 2-pin Y-harness
2Battery logo
3Input connector
4Output connectors (2)
5Battery tender connector
Figure 2. Input Connector and Battery Tender Connector
5. Install left side cover.
NOTE
  • Connect only the input connector to the battery tender connector. Connect the output connectors to device or battery tender.
  • Check the rating of any accessories used with this power supply. Do not exceed the system rating. See the service manual.
IN USE
NOTE
  • Power outlet is not switched. It remains "ON" even with ignition key switch in "OFF" position.
  • DO NOT leave items connected to the power outlet unattended.
  • DO NOT mount electronic devices with a hard drive memory on the vehicle for use or charging while the vehicle is in operation. Vehicle vibration can permanently damage the device. Refer to the device instructions to determine if the version used has a hard drive memory.
  • Keep connectors capped to prevent moisture damage when not in use.
SERVICE PARTS
Figure 3. Service Parts, SAE 2-Pin Y-Harness
Table 1. Service Parts
Item
Description (Quantity)
Part Number
1
SAE 2-pin Y-harness
69201150
Item mentioned in text.
A
Battery logo
B
Input connector
C
Output connector (2)
D
Dust cover (2)